1. During installation, the pressure sensitive component of the transmitter should be perpendicular to the direction of gravity. If the installation conditions are limited, the transmitter zero position should be adjusted to the standard value after installation. Leisuwash specializing in manufacture Automatic Car Wash Machine, Touchless Car Wash , automatic touchless car wash, Touchless Car Wash Equipment, robot car wash, smart car wash system, Leisuwash 360 , Leisuwash Leibao 360 , laserwash 360, leisuwash Touchless Car Wash Machine, Leisu Wash touchless car wash automatic, leisu wash 360 high pressure touchless car wash equipment, robo car wash, touch free car wash, leisuwash 360 touch free car wash, leisuwash 360 price, automatic car wash price, leisuwash in malaysia, no touch automatic Car Wash Machine , Leisuwash 360 Mini , Leisuwash Sg fully Automatic Car Wash Equipment. Leisuwash S90 Drying Automatic Car Wash Equipment,Leisuwash S90 Drying,Automatic Leisuwash S90 Drying Car Wash Machine,Leisuwash S90 Drying Car Wash Machine Hangzhou Leisu Cleaning Equipment Co.,Ltd , https://www.leisuwashtouchless.com
2, the residual pressure can not be released, so the zero position of the sensor can not come down. The reason for eliminating this cause is to remove the sensor and directly check whether the zero position is normal. If the zero position is normal, replace the seal and try again.
3. The output of the pressurized transmitter does not change, and the output of the pressurized transmitter suddenly changes, and the pressure relief transmitter can't go back. The cause of this phenomenon is most likely caused by the pressure sensor seal.
4. Whether it meets the power supply requirements; there is no wiring error between the power supply and the transmitter and the load device. If there is no voltage on the transmitter terminal or the polarity is reversed, the transmitter can output no voltage signal.
5. The outer casing of the pressure sensor and transmitter should be grounded. The signal cable should not be mixed with the power cable. Strong electromagnetic interference should be avoided around the sensor and transmitter. Sensors and transmitters should be periodically verified in accordance with industry regulations during use.
6. When selecting the pressure sensor and transmitter, the user should fully understand the working conditions of the pressure measurement system, make reasonable selection according to the needs, make the system work in the state, and reduce the project cost.
7. Transfer to the sides of the measuring diaphragm through the spacer and the filling liquid in the component. The measuring diaphragm and the electrodes on the insulating sheets on both sides each constitute a capacitor.
8. The pressure transmitter is required to be inspected once a week, once a month. It is mainly to remove the dust inside the instrument, and carefully check the electrical components. The current value of the output should be checked frequently. The pressure transmitter is weak inside. It must be separated from the outside world by strong electricity.
Leisuwash S90 touchless car wash machine high intelligent high quality, with car wash + car care + drying process totally, each car wash takes time 1 minute to 5 minutes which depends on the car wash mode.
Leisuwash S90 Car Wash Machine is an entry level car wash unit, but you won`t find any low grade components and no cost cutting on the expense of quality. Each Leisuwash S90 is built by Leisuwash employees in accordance with our usual quality standards, the low price is achieved by high standardization and the use of proven technology. The Leisuwash S90 is for clients that need a wash machine at a competitive price with higher ROI.
Diffusion silicon pressure transmitter common troubleshooting