Four considerations for lifting the slurry pump

When the slurry pump is lifted, the slurry pump accessories should pay attention:

1. Lift the horizontal pump without base or only with a separate seat. The lifting center of gravity should be at the square hole on the side of the bracket close to the pump head, and the wire rope should be connected with the lifting hook vertically upwards. In order to maintain the balance of the slurry pump, an auxiliary lifting wire rope should be provided between the eyebolt on the pump housing and the lifting hook. The lifting ring screws on the bracket cover and the front and rear pump casings are provided for disassembling the bracket cover or the front and rear pump casings. They cannot be used alone to lift the integral pump to avoid accidents.

2. Lifting belt motor and horizontal pump with common base, the lifting center of gravity is at the square hole of the bracket close to the coupling, and the wire rope is passed through the vertical upwards to connect with the lifting hook. In order to maintain the balance, the pump must be in the pump. An auxiliary lifting wire rope is provided between the eyebolt above the shell, the motor eyebolt screw and the lifting hook.

3. Horizontal pump units with intermediate transmissions, such as couplings, shall be lifted separately.

4. The place where the wire rope is in contact with the pump body should be protected with soft materials so as not to damage the appearance of the pump or cause the wire rope to cut off.